- 大型设备
- 提升设备
- 喷浆设备
- 铁路物资
- 安防救援设备
- 钢材
- 排水设备
- 运转设备
- 矿用门
- 支护设备
- 防爆电器
- 其他
- 化工产品
- 通讯设备
- 瓦斯专项治理
- 通风除尘设备
- 电机
- 仪器仪表
- 凿岩设备
- 农用无人飞机
- 智能锁
- 机器人
乳化液泵站主要用作煤矿井下机械化采煤推移运输机的动力源,也适用于地面清洗设备清洗设备以及液压设备作动力源,工作液为3-5%乳化液或清水。
因产品生产批次、具体型号不同,以上图片仅供参考,详情可联系我们的销售人员进行具体核实!
BRW40/20型乳化液泵站型号参数
乳化液泵站应用于各种矿山、国防、隧道及坑道作业中。主要是为采煤工作面、掘进机提供高压乳化液,可满足普采工作面、综采工作面的不同要求。自动进水、泵超压自动卸荷、乳化液配比浓度可自由 调节,具有操作灵活、移动方便、高效、节能、安全、耐腐蚀、抗磨损、传输距离远等特点。
Emulsion pump station used in the operation of various mines, national defense, tunnel and tunnel. Mainly for the coal face, tunneling machine with high pressure emulsion, can meet the general mining face, fully mechanized face different requirements. Automatic water inlet, pump overpressure automatic unloading, emulsion concentration ratio can be adjusted freely, has the advantages of flexible operation, convenient movement, efficient, energy-saving, safety, corrosion resistance, wear resistance, transmission distance and so.
Pump before the start, should first carefully check the oil level is in conformity with the provisions, the oil level should not be less than the oil line. Check all parts components without break, fasteners, especially the slide lock nut should not loose. The connecting pipe is penetration, suction, discharge hose is folding and bending die.
No confirmation of fault, manual unloading valve switch box group, will air suction cavity plugging loosen, the suction chamber of the air discharge, liquid after tightening. To move the motor switch, rotate the arrow direction of motor is correct.
The pump is started, should pay close attention to the running state, no-load running 5 ~ 10min pump, pump should be no abnormal noise, jitter, pipeline leakage phenomenon, check the pump head screw plug, pump and tank coupling screws should be no loose, manual unloading valve switch off the tank, can be put into normal operation.
Pump after the operation, should pay attention to the temperature is not too high, the oil temperature should be lower than 85 ° C, notice the oil change is not lower than the line below, liquid temperature not exceeding 40 ° C.
在泵运行中要注意栓塞密封是否正常。In the pump is running to the attention of embolism seal is normal.
泵站在运行中,公称流量下,压力从空载逐渐加载到所 需压力。公称压力下,泵站各部位不得有松动、渗透液现象。Pumping station in operation, the nominal flow, pressure from no-load gradually loading to the required pressure. Nominal pressure, parts of the station may have loose, permeate the phenomenon.
产品分类